Gold And Copper Processing Plant

Gold And Copper Processing Plant

The structural principle of Gold And Copper Processing Plant

Guide: Gold And Copper Processing Plant is one of the indispensable equipments for various stone production lines and sand production lines, and it is especially widely used. Understanding the basics of the Gold And Copper Processing Plant, its working principle and common faults and maintenance are essential for the selection, use, maintenance and maintenance of the equipment.

Introduction to Gold And Copper Processing Plant

The Gold And Copper Processing Plant is a stone crushing device that uses impact energy to crush materials. It is generally used for secondary crushing after jaw crusher. It can crush various coarse materials with feed particle size not exceeding 500mm and compressive strength not exceeding 350MPa. The medium and fine materials, and the size of the discharge can be adjusted, and the unique performance of the crushing specifications is favored by the majority of users. It is widely used in various ore crushing, railway, highway, energy, cement, chemical, construction and other industries.

Main structure of Gold And Copper Processing Plant

The Gold And Copper Processing Plant is mainly composed of a rotor, a counterattack, a hydraulic opening device, a transmission part and a frame. Its structure is very simple, making it small and lightweight. Moreover, its large feed port and high crushing chamber make the Gold And Copper Processing Plant have the advantages of large feed specifications and high processing capacity. It has two or three crushing chambers, which can make the Gold And Copper Processing Plant meet the needs of different production operations of coarse, medium and fine crushing. The customer can easily change the discharge size by adjusting the gap between the counterattack and the hammer.

Gold And Copper Processing Plant working principle

When the Gold And Copper Processing Plant is working, the rotor rotates at high speed under the driving of the motor. The material entering from the feeding port collides with the hammer on the rotor, and is broken by the high-speed impact of the hammer; the broken material is counterattacked to the counter lining. The plate is crushed twice; finally discharged from the discharge port. It can be seen from this that the Gold And Copper Processing Plant is suitable for processing a variety of materials below medium hardness. The material is cracked by the impact of the joint surface, which makes the shape of the finished product cubic, no tension crack, good grain shape, and meets the grade standards of various aggregates. The crushing principle of this “stone hitting iron” also makes the Gold And Copper Processing Plant have the characteristics of large crushing ratio, high crushing efficiency and low energy consumption. Moreover, the material directly contacts and collides with the plate hammer and the counterattack plate, and the wear is serious, so the daily maintenance of the Gold And Copper Processing Plant is also very important.

Gold And Copper Processing Plant maintenance

  • Strict inspection before starting the machine to see if the wear parts are worn and the bolts are loose;
  • Always check that the lubrication system is normal, pay attention to the temperature of the rotor;
  • Feeding must be uniform, if there is abnormal vibration or noise, stop the inspection;
  • The hammer and rotor should be replaced in time after wear;
  • After the machine is stopped, it is necessary to clean all parts of the Gold And Copper Processing Plant to ensure its sanitary cleanliness.

Hope that the above information can be useful to you, if you need to consult, please contact our online customer service!

Leave A Comment

Required fields are marked *. Your information will not be published or shared.