Copper Ore Beneficiation Process Equipment

Copper Ore Beneficiation Process Equipment

Copper Ore Beneficiation Process Equipment has low output

In many mine production, it can be found that the Copper Ore Beneficiation Process Equipment equipment will have a problem of reduced production after two years or more. Once the output is reduced, the engineering benefit will be reduced, so this is an urgent problem to be solved. To this end, the technicians of Shanghai Shibang Machinery Co., Ltd. went to the site to investigate and analyze the reasons for the decline in Copper Ore Beneficiation Process Equipment production, which gave corresponding solutions to these reasons:

The first point is that the yield of the raw material is deteriorated due to the deterioration of the raw material. Because the original fabric is uneven, the layer formed in the mill is unstable, which causes the vibration of the Copper Ore Beneficiation Process Equipment. Therefore, it is necessary to change the easy from the raw material.

The second point is the drop in the output of the Copper Ore Beneficiation Process Equipment caused by the decrease in the grinding pressure. Because the overflow valve of the hydraulic station is not sensitive enough, the equipment is pressurized frequently during the operation, and when the powder in the mill increases, the The main motor current should not be too high, and the grinding pressure will decrease, so the relief valve of the hydraulic station can be improved in production;

The third point is that the output of Copper Ore Beneficiation Process Equipment equipment caused by insufficient air volume in the system is reduced, because the Copper Ore Beneficiation Process Equipment is circulated and discharged in the mill by the airflow. When the air volume of the system is insufficient, the fine powder that has been ground still stagnates. In the grinding, the phenomenon of grinding is caused, the equipment is seriously improved and the output is plummeted;

The last point is that the perennial use makes the internal parts of the equipment wear out seriously, which causes the parts to fail to work properly and eventually causes the output to drop. Therefore, the output of the equipment can be changed by replacing or repairing the parts.

Leave A Comment

Required fields are marked *. Your information will not be published or shared.