Cost Of Cement Production Plant

Cost Of Cement Production Plant

Cement Production Plant troubleshooting method

Cement Production Plant powder failure

Problem 1: Cement Production Plant does not produce powder or powder, and has low output.

Causes: 1, the locker is not adjusted well, the seal is not strict, causing the powder to suck. 2, the blade wears a lot, the material can not afford to shovel.

Remedy: 1. Check and adjust the seal of the locker and find that the air leak should be scraped. 2. Replace the new blade.

Question 2: The finished crusher of the Cement Production Plant is too thick or too fine

Causes: 1. The blade of the analyzer is seriously worn and cannot be graded. 2. The fan air volume is not appropriate.

Remedy: 1. Replace the length of the blade and turn off the air volume of the small fan to solve the rough. 2, too fine should increase the volume of imported air.

Cement Production Plant host problem

Problem 1: The current of the Cement Production Plant rises and the fan current drops.

Causes: 1. The feed is excessive, the air duct is blocked by the powder, the pipeline exhaust is not smooth, the circulating airflow generates heat, the main current increases, the machine temperature rises, and the fan current decreases.

Remedy: 1, reduce the amount of feed, remove the wind tunnel powder. 2. Open the large air duct valve, and the temperature of the incoming material is controlled below 6 °C.

Problem 2: Cement Production Plant main engine is noisy and has large vibration

Causes: 1. The feed amount is small. The blade is severely worn, the material cannot be shoveled, and the anchor bolts are loose. 2, the material hard impact is large, or the material layer 3, the grinding roller grinding ring is seriously deformed.

Remedy: 1. Adjust the feeding amount and replace the new blade. 2. Replace the feed size. 3. Replace the grinding roller and grinding ring.

Cement Production Plant main equipment problem

Problem 1: Vibration of the fan of the Cement Production Plant

Causes: 1. Powder or wear imbalance on the blades. 2. The anchor bolts are loose.

Remedy: 1. Remove the leaf powder or replace the blade. 2. Tighten the anchor bolts.

Question 2: Cement Production Plant transmission and analysis engine oil tank heating

Causes: 1. The viscosity of the oil is large and the oil is thick. The thread pump oil cannot be used to make the upper bearing lack of oil.

Remedy: 1. Check if the oil grade and viscosity match the requirements. 2. Check the running direction of the analyzer.

Problem 3: Milling machine grinding roller device into the powder bearing damage cup

Causes: 1, oil cut, or seal damage. 2. Long-term lack of maintenance and cleaning.

Remedy: 1. Refuel in time according to the specified time. 2. Regularly clean and replace the oil seal.

These three types of problems are common faults in Cement Production Plants. Therefore, when in the production, when encountering the above problems, don’t be too nervous, check them one by one.

Leave A Comment

Required fields are marked *. Your information will not be published or shared.